Quote:
Originally Posted by Shrapnel[Op-For]
I noticed my loading nozzle is sticking slightly inside were the plastic piece meets with the hop up rubber? When I manually cycle the bolt, i can see that the nozzle stays in place briefly before popping back. I have inspected the nozzle and oiled the o ring with silicon oil.. the nozzle itself looks completely fine as does the return spring. Is this normal? Or could it be why the gun vents all the gas from magazines randomly.
|
Might be sign that your hop-up rubber is torn or swelt.
Mine stick for the first half inch of travel (just enough to see it) then pops back. The tip of the nozzle interfaced with the rubber, not the hop-up chamber, so it might get stuck. It could cause the venting you are getting (especially if your bolt locks back when the venting occurs).