Quote:
Originally Posted by Drake
So once everything is cured, the floorplate is basically "glued" into the mag? Or does that stuff separate easily?
|
essentially yes. it's basically a soft silicon so you can pull it apart if required for further maintenance. It just may take a little effort. I would guess you can also remove the flow/output valve on some mags and insert a probe to assist pushing it out. but considering how it cured in the nozzle/tip, it's fairly easy to remove. it pretty much fills all the gaps where gas can leak out.
The mags that I have repaired were chronic leakers and were pretty much sitting for the past couple years.