M4/M16 Thumbhole Sniper Stock

[SultanOfShwing]

I have this stock: http://www.wgcshop.com/WGC_Shop/imag...-m16-stock.jpg

But the problem is that I'm missing the back piece. Anyone know where I could possibly get my hands on one? If not I might just try modifying it so I can use the back piece from a regular M16 stock. If I do that though it will be a few inches shorter than an M16 stock and the battery might not fit as well.

[TokyoSeven]

Ah! you managed to aquire a right sniper stock. As far as I know they are now out of production, and unfortunetly the only thing I can recommend is to attempt to fabricate something yourrself or see what you can find that will fit.

Ive always wanted one myself but after reading a few reviews in regards to how poor its build quality was and how it can leave open gaps between the reicever and the mechbox I decided not to pick one up. However thats just from the reviews Ive read myself, your experience maybe entirely different.

[SultanOfShwing]

Yeah it doesn't look like it is up to the level of quality of my current stock by any means. But it looks so cool. If I end up modifying it to fit I'll post up some pictures of my hack job.

[TokyoSeven]

Ive been considering fabricating one myself using a miad grip and, a full m16 stock, a dowel, some fiber glass molding and spray paint. It would look nice and dandy but it would be hell to get on and off.

[SultanOfShwing]

It would be pretty easy for me to modify the end of my sniper stock to accept the back piece from my normal M16 stock. The only issue I would have is that the screw that holds the stock in place might be too long. When I get off work I I'll see how deep I can screw the screw into the upper reciever. I would need to screw it in about an inch deeper than I normally would. If that doesn't work I would need to find a shorter screw and I have no clue about going about that one.

On a side note, how much of the gun do I need to disassemble to remove the trigger grip?

I really want to put this stock on....it looks so good when I line it up so it looks like it is attached.

[TokyoSeven]

To remove the pistol grip all you have to do is remove the motor plate from the pistol grip, remove the motor and remove 2 small screws inside the pistol grip that connect the grip itself to the mechbox. Fairly simply.