I'll sound like a dick then; you bought a piece of crap. It failed because it's a piece of crap. It's what? $36 US?

Right now your choices are; try to fix it by shoving that rod down the barrel, buy another one and take a chance again, or buy a far better gun than that and keep this one as a display piece.

Good brands to look for; Marui, ICS, CA. That's about it.

If the Well is a clone to the TM P90, your best bet is to remove the front end before attempting to unclog the barrel. With the front group removed, the mechbox nozzle wouldn't block the bb passage.

If you don't have a clearing rod, you're going to have to make one. Try cutting a wire coat hangar and bend the wire stock straight. Wrap the tip in several layers of tape so it doesn't scratch the inside of the barrel and use the makeshift clearing rod to push the bbs out.

Stick to better grade pellets which are less likely to jam. Low grade pellets may mostly be round, but there are a few obround or very badly shaped pellets which may jam your barrel and have additional rounds packed in.

Is it just me, or should this have been trashed long ago?

no.... whats wrong?

HE HAD A QUESTION.

...about a gun that costs as much as a TM lowcap and is not worth fixing.

Hit it with a rock

were would you get a WELL D-90-H gun like that in canada?

check some dumpsters

no

HAHAHAHA
nice

You should know better than to even ask that by now. Really.