Airsoft Canada - TM New Products.

Page 2 of 2

Show 100 post(s) from this thread on one page

Airsoft Canada (https://airsoftcanada.com/forums.php)

- Airsoft Guns Discussion (https://airsoftcanada.com/forumdisplay.php?f=53)

- - TM New Products. (https://airsoftcanada.com/showthread.php?t=69648)

Styrak

October 25th, 2008 20:00

Quote:

Originally Posted by Kos-Mos (Post 848049)

Actually, since you already have plenty of gas in a single mag, you could extend the "bb" section and leave the "gas" section hollow. That would reduce the weight of the mag.

I had a WE HiCapa that was doing that too.

I should have taken pictures to know what parts to dremel...
Now I would have been rich...

Uh, the gas section basically IS hollow. So I don't think it would do much for the weight.

Kos-Mos

October 25th, 2008 21:59

Quote:

Originally Posted by Styrak (Post 848074)

Uh, the gas section basically IS hollow. So I don't think it would do much for the weight.

I meant that the reservoir section can be left the size it is. So that the liquid propane weight is not added to the longer magasine.

Amos	October 25th, 2008 22:21

Quote:

Originally Posted by Kos-Mos (Post 848213)

I meant that the reservoir section can be left the size it is. So that the liquid propane weight is not added to the longer magasine.

Or than can make a 300 round double stacked monster that takes a whole tank o' coleman each fill :D :D :D

All times are GMT -4. The time now is 11:06.

Page 2 of 2

Show 100 post(s) from this thread on one page