p-90 upgrade
 

i was woundering if anyone could tell me what i need to get to up grade my p-90 to shoot 350-400 fps im new to upgrading

Spring and bushings.

is it that simple, or will you run into problems in the end? im using a J type battery at 9.6v, and i want more power, eventually more range, but ill just convert to a ps90 barrel. is it as easy as installing a new spring (120-140) and some bushings?

Yes, yes it is. Only caveat is that you need V6-specific bushings. I ran a PDI150% with Guarder bushings and a J-batt, it was perfect. Things started going wrong when I replaced more stuff with Systema/Guarder etc.

Bushings and springs are the most basic upgrades. Obviously an upgraded gun will increase wear and tear, so over time, you'll need to replace other parts.

Not likely on a P90 unless you're pushing 400FPS.

what would you recommend for a spring (110,115,140)? sorry for the hijack shadowninja...

Check out ILLusion's spring chart, the numbers will be very close to what you'll get... in fact, yours might be a bit higher with everything else stock. The only other part you might need to replace is the spring guide, and that's only when you're close to 400FPS.

what FPS would i get if i used a 150% spring

I dunno, look at the freaking chart.

how the hell do you get a j type battery to fit in a p90?

huh, woulda wished i knew that before i got it.

so, i understand what i need to cut, but i know it wont fit around the wires. I see i need to do something around the fusebox. Ive never opened a AEG before, so whats the easiest way to do this without having to do to much?

Unscrew the backplate... chop off the bottom half below the screw holes...

Remove the fuseholder, splice the wire ends back together, shove it all in, reinstall the backplate.

That's all you need to do.

tankdude obliged to do it, he says its easy, someday, ill open up an AEG...