Motor Gear
 

Hey guys. My motor's gear has small dents on the lower part, would this be because the motor is too far back?

http://i33.photobucket.com/albums/d9.../CANSOF024.jpg

http://i33.photobucket.com/albums/d9.../CANSOF022.jpg

yup, it's too low, raise it.

right now there's not enough damage to cause any alarm, but it is speeding up the wear process.

Alright, like a few turns?

Thanks.

Until it sounds the quietest. Take a single shot, adjust, take a single shot, adjust. Keep going until it makes the least noise and sounds the smoothest.

Well I've had my gun upgraded to 400 fps and it makes more of a grinding noise now than it did before (310 range). Is this normal, it's with different gears too. I can't really tell the difference in noise when adjusting it, because I tried the other day and didn't really notice a difference. ;)

This is normal.

You won't get a perfect fit unless your shim job is matched perfectly to the motor/grip you are using.

If your gun is as silent as it can, then you don't have any problem.

Thanks for the help guys!