Cyma SVDAeg
 

Was looking to upgrade the barrel to start it off, From what I know its a 650mm but can't seem to find a place that sells one that large. Also the spring in this would be a standard aeg spring?

Was wondering if any one could also recommend any other upgrade that would be easy to do for some one with almost no exp with these aeg's

-prometheus 650mm 6.03

-rhop

-a really good shim and aoe job

-simple mosfet or precocking mosfet

-11.1 lipo

makes it into a sweet dmr

What would be the difference between a lipo and the standard ones?

Everything Off_Kilter said, but perfect the compression.

When changing the inners for it, would you also recommend buying the better gears for the gear box. Like the ones prometheus also makes?

Also adding a sorbo pad?

Also since the SVD is still makes as a DMR/DM instead of a sniper rifle, I would still need to run it at the same cap as a AEG? Now for the springs in it. DO they use the sames springs as an AR or different ones?

Eses proprietary gears I believe(4 gear system) and they're fine.

Sorbo pad isn't necessary as the gearbox is really strong and you wont be running crazy RPS. Also the piston is oversized so not sure how that would affect the sorbo. You also dont want to lose volume in the cylinder which is what the sorbo will do.

I would get the S&T midcaps they work great.

Springs are standard aeg springs.

Looked at the places with the above listed stuff and it's cheaper then I thought I would be spending.

Basicly going to try and do what Off_kilter said

Barrel
rhop
battery
and a mosfet

and then have some one do the shim and aoe job

For the r-hop something like this http://www.airsoftgi.com/product_inf...ducts_id=10710 ?
Or is there a better one out there?

http://www.airsoftstore.ca/index.php...u8q4scvf2ui7o3

http://www.airsoftstore.ca/index.php...u8q4scvf2ui7o3

Then something like this mosfet?

http://www.airsoftstore.ca/index.php...roducts_id=135

With deans connectors is it just the connector type part that is different? Should be easy to change wire ends on the wires. But does deans use different wires altogether or just the connectors?

none of those mosfets have precocking. For what you're doing this would be fine. If you go to a quality 11.1 the trigger response will still be really good even without precocking.

You should really switch everything you have to deans they're much better connectors.

http://www.airsoftstore.ca/index.php...roducts_id=209

I wouldn't recommend r hop to people who don't like to disassemble/tune their guns a lot

I don't mind having to tinker with it till I get it perfect. Rather get the exp with my own guns and only rely on a gun doc for something big.

Any one know of a canadian retailer who sales the prometheus barrel?