Removing face shield from JT Flex 8
 

I've found topics where people mention being able to remove the goggles on the JT Flex 8 "easily", but can someone help me with the specifics? I've removed the visor, but it looks like the top part of the mask attaches with 3 posts to the top of the goggles and I can't get the posts out. Also, how will the strap come out? Will I be able to get the goggles out without cutting or breaking anything?

4 points (similar mounting system like the visor) - one on each side of the nose-bridge piece, and one at each edge of the face mask part

Found the four posts at the bottom of the goggles, and the three at the top, but they are really stuck in there and my fingers are in agony. Tried a few hard objects I had lying around to try to push them out, but no luck.

Just pull on the mask to remove it from the goggle frames. Push the strap through with a butter knife.

Managed to get the posts out and the goggles free with a lot of pulling, but there's no way to free the strap without cutting the plastic. Maybe I'll just use the full mask for now.

Removing the strap is easy. Grab the goggles in one hand and the strap in the other hand and pull. It will come out with alot of pulling. To put the strap back in the goggle frame, you take some needle nose pliers poke them threw the slot in the goggle frame. Then grab the strap with the pliers and pull it back through the slot.