SOLVED PLEASE DELETE
 

http://i49.photobucket.com/albums/f2...g/DSCF1574.jpg

When I move the hop-up wheel all the way onto the little piece that should be inside wheel I have an issue. The little piece seems to come short and when you turn the wheel to adjust it just spins and clearly isn't moving the little piece that the green arrow is attached to.

If you are an AUG user can you let me know if mine looks a little short or if there is a piece that I am missing. This is photo of the end of the upper reciever section.

Thanks
Dave Horton
EDIT-my appologize for the GIANT pic

oh my goodness I searched for AUG papers but somehow missed the sticky at the top of this section. Sorry for missing that folks. It looks like I am missing a small round piece that goes on after the hop-up dial goes on to make it stay agianst the lever. Still if any Aug users can tell me if that's right or not that would be great.

hey man, the little tab that the green arrow is pointing to should be a little bit longer. The pic you have is a bit hard to tell as it's on an angle but the tab shoudl stick out about 1/8" or so. It has to fit in the wheel that is the right of the green arrow. You'll notice in that wheel there is a grove on the inside .. the wheel sits against the lever (green arrow) such that when it turns, the lever moves your hopup up and down. There is also a peice that sits to the right of the wheel that locks it onto the hopup.

this means I am missing the piece that locks it up to the hop-up and that the lever is missing that 1/16 of an inch. Thanks for the help I figured this was the issue but just wanted to make sure.