416 inner barrel question
 

Simply put, what is the inner barrel length of a JG 416 with the crane stock? I need to know exactly for an upgrade I am planning.

About a regular 363mm M4 barrel with 3cm cut off. So 330 mm.

Mine was under 300mm!
Dont ask my why because I dont know but it was nowhere close to the end of the outer barrel.

My inner barrel is within an inch to two inches to the outside of my flash hider. Styrak is that just an educated guess? I don't want to end up buying a barrel and have to worry about cutting it down or it being too short.

I would suggest that you simply remove the inner barrel from your 416 and measure it. That way you know for sure without any guesswork required.

Mine was 285mm.

Just measured mine at 260mm, aprox. 1 1/2 inches from the tip of the flash hider making it just the right length for it to look perfectly real.

Ok Im going to guess that these barrels are all different lengths then or something lol. I'll try pulling mine out tonight and measuring it up then.

Lol... yeah JG is very very random when it comes to consistency in their product.

Yeah, it seems to be that way from all reports of JG guns. One example being the mechbox in mine. Everyone so far seems to report an SB-stamped mechbox, whereas mine is stamped UTG instead.

I was curious, so I just checked out my inner barrel. Mine runs the full length of the outer barrel right to the flash hider. It measures up at 288 mm.

I cut off 3cm and it worked fine. Stuck out of the outer barrel a little, but not so much that you could see it through the cuts of the flashhider, viewing the gun sideways.