DBOYS VS JG v2
 

whats better v2 gearbox wise?

the gearbox that the DBOYS has in its SCARS?

OR

The V2 that the JG hk416 has?

please reply only if you have read up and have seen the internals of both.

Even though I have not seen both I would still like to contribute.
The mechbox that I recieved in the 416 was fairly decent, alot more than I expected.
The internals were fair but it still required a good clean down reshimming and regreasing, as well as replacement of its nylon bushings. For more info on the mechbox dig my old JG 416 review. Its been noted that even though all 416s have the same internals, newer JG models have been comming out with metal bushings and mechbox shell brands have been noted to vary from gun to gun.

I bought a JG V2 complete mechbox...the piston was split in two before I even had a chance to fire it once. That said once it was replaced with a TM stock piston it worked fine. You may have to change a few things..like the anti reversal latch as the JG version allows some (albeit fine) shifting when you release the trigger. It seems to be working just fine with a new piston and spring, and seems quite sturdy. It's a pretty good "cheaper" alternative to some of the more expensive ones on the market like G&P etc. That said I would rather have a G&P or Systema complete mechbox drop in replacement though.

reason Im asking is that the Dboys SCAR one looks reinforced just like a G&P,

the JG is also said to be reinforced but I cannot see the extra meat that the Dboys has in the rear.

Reinforcement in the rear doesn't really matter. It's the front where every V2 fails.

i got the new systema clone jg black gear boxes (also know as the 416 mechbox) came to me el messed and needed to be sent out to be fixed. but it runs great now.

I've owned the older JG box once with plastic bushings and ran it in my SPR. It was shooting 390fps with an AK inner barrel. It ran like a beauty.

I'm not sure how these new ones are now, with the mosfet and such. I'm pretty much interested in getting one again.

snice when did they start putting mosfets in them?

Since the new versions came out. :p

ohhh im out of times lmafo can they be purchased alone? any info im now intrsted in them as im now running lipo and want to switch up any pricing?

EDIT NVM FOUND OUT WERE AND HOW MUCH AND ALL THAT JAZZ AND THE INFO PRETTY NEAT

Yeah JG mechbox and motor sets could be purchased alone for a while now. I think huang might have them, or I can get them for you.

can you quickly explain what their standalone fets will do dosnt it make it better when rining on lipo? like it drops the voltage down?

Don't know, I'll leave that to someone else.

My understanding is that it bypasses a lot of voltage from the switch mechanism and puts it through the FET. There's only a small signal wire from the switch to the FET, which saves your contacts and switch from being damaged/melting/etc when running powerful batteries.

lol exzactly why i was told to run fets while running lipo if i plan to do bursts i was looking at the thread on asc http://www.airsoftcanada.com/showthread.php?t=75828 this one, and his has a third wire hanging from the motor area is it busted or something and need to be opend to wire it to the trigger switch?

The new JG boxes have ball bearing bushings, reinforced, mosfet.
Huang has them.
They aren't really "SYSTEMA" clones, they juts have it on the box that says SYSTEM lol.