|
Remove the motor and handle (two screws on bottom of handle and then two inside) remember the motors orientation. Look inside, maybe with a light, and you'll see a gear imediatly inside. On the side oposite the trigger you should see a metal peice with a very small thin wire on it, this is the anti-reverse latch.
DO NOT GET CONFUSED! This small thin wire is not electrical, it is a spring mounted to the anti reverse latch. That springs hook identifies the latch while looking through the hole.
Use a sturdy item thin enough to get in and strong enough to apply force (think sticky jam jar) while still managing to grip the latch. I use needle nose plyers that are for bead work and angle to about 40 degrees (where is that button?!)
Best of luck [B]curlex[B]!
__________________
Con Murder
Dark Rhino
L.A. Airsoft
|