|
D.
On the mag main valve take the feed lips off and make sure that the valve opening is facing up. The port is nearly half the valve...and if not facing straight up it causes problems.
Try swapping the floating valve and spring out (or trying different combos). How hard is that one shot? Normal, weak, too strong? Should have asked...I had a spare one for that too I think...
Feel free to clip that spring I gave you...I was pretty sure it was a stock one, but maybe it wasn't.
Does it vent when it half-racks...or does it cut off the gas properly, just doesn't cock back far enough?
New loading nozzel isn't too tight on piston head?
The little knocker cut off moves freely up and down? If it's sticking it may hang up the slide enough to stop it.
Barrel hasn't gotten all mucked up?
Too bad you're not closer, just bring it by and we'll put in on the bench for a bit.
T.
|