Great
Tell us how it perform!
My block is 23mm X 23mm X 32.7mm. And I needed to place it a bit forward (like 0.3mm) so a 33mm long block should be perfect.
I ajusted my block with the bolt and the spring block in place. using a straight rule and pulling the bolt backward you can see if it touch the PVC block or the normal block first. My set-up allow the bolt to touch the PVC block before and there is like 0.2mm of free space between the normal block (spring rod) and the bolt.
I should receive my parts today or tomorrow so I'll be able to try it out.
On a different note: I noticed that the brass cylinder is nor parallel to the upper body and that result in the bottom of the bolt getting into contact with the brass cylinder like 8-10mm before battery. I'll try and take some pics tonight.
Did any of you have that same problem? Can somebody take a look and velidate of that angle if normal or not? I can easyly see the angle between the brass cylinder and the upper body. I am under the impresion that it should all be aligned. not angled
Thanks