Airsoft Canada - View Single Post - Fitting new slide and outer barrel/chamber

Tuthmose · February 13th, 2010, 23:21

Thanks, Rock and Roll Outlaw. I'm thinking the outer chamber is the way to go as well, but would feel better about it if one of the GBB pros (Illusion, RacingManiac, looking at you here . . .) concurred. No worries about going to town with a Dremel, thought :-) The fact that it cycles and shoots reliably means that not too much material needs to taken off, regardless of where it comes from.

I've had such good results from the upgraded airseals in my stock Hi-capas that I'd rather not go back to the thinner stuck ones unless it was the only way to solve this problem. They make the hop-up unit gap a bit in those set-ups too, but it looks like the plastic outer-barrel/chamber unit has a bit more room to allow this than does the Tanio-Koba aluminum unit.

-Tuthmose

February 13th, 2010, 23:21	#3
Tuthmose Trader rating Join Date: Jan 2010 Location: Northern VA	Thanks, Rock and Roll Outlaw. I'm thinking the outer chamber is the way to go as well, but would feel better about it if one of the GBB pros (Illusion, RacingManiac, looking at you here . . .) concurred. No worries about going to town with a Dremel, thought :-) The fact that it cycles and shoots reliably means that not too much material needs to taken off, regardless of where it comes from. I've had such good results from the upgraded airseals in my stock Hi-capas that I'd rather not go back to the thinner stuck ones unless it was the only way to solve this problem. They make the hop-up unit gap a bit in those set-ups too, but it looks like the plastic outer-barrel/chamber unit has a bit more room to allow this than does the Tanio-Koba aluminum unit. -Tuthmose __________________ - - - - - - - - - - - - - - - - - - - - - - - - - - - - "Attack Everything" - Lanoe Hawker, WWI Ace Last edited by Tuthmose; February 13th, 2010 at 23:23..