Airsoft Canada - View Single Post - G&G M-16 front end rebuild.

Jackarutu · March 23rd, 2010, 02:17

You need to use a Brownells Front Sight Jig Fixture to hold the sight and barrel and then use a drift punch and drive the pins out of the sight. After that there is a set screw on the bottom that needs to come out. If you have a sling attachment on the bottom you will need to drive the pin out of it too before you can see the set screw and Bob's your uncle.

March 23rd, 2010, 02:17	#4
Jackarutu Trader rating Join Date: Sep 2009 Location: louisiana	You need to use a Brownells Front Sight Jig Fixture to hold the sight and barrel and then use a drift punch and drive the pins out of the sight. After that there is a set screw on the bottom that needs to come out. If you have a sling attachment on the bottom you will need to drive the pin out of it too before you can see the set screw and Bob's your uncle. __________________ I must not fear. Fear is the mind-killer. Fear is the little-death that brings total obliteration. I will face my fear. I will permit it to pass over me and through me. Last edited by Jackarutu; March 23rd, 2010 at 03:12..