Airsoft Canada - View Single Post

doc_pathfinders · May 10th, 2010, 09:24

Dear all,

i'm looking to upgrade a few of my AEG's to using MOSFET, i have done some research but i was looking for advice from other GunDoc's as to what brand they use, or advise me to use...

the guns that i'll be upgrading are :
1. Top M249 W/PGC gearbox (hummer 1300 motor, with an m120 spring) will be run on a 7.4 lipoly
2. SPR mk12 Mod0 that will be upgraded to an M150 spring, guarder infinite torque motor etc that will be run on a 11.1v lipoly OR a 9.6v 3000Mah NiMH, if it can hack it.. ( i doubt, but i have three of these batt's and i'll make use of them if i can)
3. classic army M4, standard internals (shooting at around 380FPS) that i will run on either a 7.4 or 11.1 lipoly

so i'm looking for a total of three and it would be great if the one's i'll run in the M4's could support active breaking, but i'd preffer what works then any fancy features that may reduce the reliability.

i'm not too worried about the cost, but i want something that will work and has been shown to take a fair bit of abuse (my m249 will get plenty of it)

i'm very open to suggestions, but i would like suggestions toward places that have them in stock, as some locations i have seen written about haven't had stock for a while.

May 10th, 2010, 09:24	#1
doc_pathfinders Trader rating Join Date: Dec 2009 Location: Cyprus	MOSFET suggestions Dear all, i'm looking to upgrade a few of my AEG's to using MOSFET, i have done some research but i was looking for advice from other GunDoc's as to what brand they use, or advise me to use... the guns that i'll be upgrading are : 1. Top M249 W/PGC gearbox (hummer 1300 motor, with an m120 spring) will be run on a 7.4 lipoly 2. SPR mk12 Mod0 that will be upgraded to an M150 spring, guarder infinite torque motor etc that will be run on a 11.1v lipoly OR a 9.6v 3000Mah NiMH, if it can hack it.. ( i doubt, but i have three of these batt's and i'll make use of them if i can) 3. classic army M4, standard internals (shooting at around 380FPS) that i will run on either a 7.4 or 11.1 lipoly so i'm looking for a total of three and it would be great if the one's i'll run in the M4's could support active breaking, but i'd preffer what works then any fancy features that may reduce the reliability. i'm not too worried about the cost, but i want something that will work and has been shown to take a fair bit of abuse (my m249 will get plenty of it) i'm very open to suggestions, but i would like suggestions toward places that have them in stock, as some locations i have seen written about haven't had stock for a while.