Quote:
Originally Posted by THe_Silencer
That's really useful to know! Now I have a new issue: I've tried installing 13:1 high speed gears and it refuses to cycle. It always jams up after a few shots. After hours of tinkering, I found out that my anti-reversal latch is the culprit since my mechbox cycles perfectly w/o it. Is there anything I can do such as increase/release the tension on the spring? My stock XYT gears cycles fine so that's why I don't think my ARL is damaged.
|
I suggest you don't run your gearbox without the AR latch unless you have some kind of fancy shmancy electronic device that is slowing and stopping the drive train without causing the gears to move in reverse.
Check your shimming. and check the shimming on the AR latch. I had to shim up my ARL on my P90 because the AR tensioning spring was contacting the spur gear.
__________________
Do you know what ruins airsoft?
(Chair), (Drama), (Air), (Sugar) softers, filthy casuals
---
Quote:
Originally Posted by mcguyver
it would appear I am not first up in this gang-bang
|
---
WANTED PTW Receiver PRIME, STG, Factory
|