[KEVORKIAN]

WE PDW

I must say that this is my favorite GBBR to date!
This little wonder packs a punch and the recoil is simply amazing!!
I found the original KAC pistol grip too small & slippery for my liking so I swapped it for a RS Hogue AR grip (minimal modification).
As for the RS PMag, all of my WE mag internals have been converted which allows for a custom fit resulting in maximum gas efficiency!If I can make one suggestion it would be to ditch the stock PDW mag that it comes with! Its' gas capacity is much smaller and that results in the guns inability to cycle/function properly! Stick with the original WE M4 mags and you'll be just fine.

On a side note, I have noticed how well this gun recoils and I think this is why I think the lower receivers are breaking! Does anyone know if there is a CNC version of the bolt coming out? The weight of the stock bolt is too heavy and it transfers too much force to the rear of the receiver...I'd like to see one made out of aluminum like the one BoomArms made for the SCAR!!!














WE internal mag comparison:
WE PDW (left) Original WE M4/SCAR (right)
The PDW cycles much better using the original WE M4 style mag.



The PDW mag internal is proprietary to the plastic shell it is housed in and cannot be modified to fit a RS PMag outer shell.



I found that the PDW rubber seal atop the mag was too recessed and did not provide a very good seal against the brass tube when inserted into mag well. This resulted in poor gas efficiency, fewer shots per mag and the bolt would not lock back...at all !!