Airsoft Canada - View Single Post - WETTI/AWSS - M4/SCAR/HK416

Dart · September 24th, 2010, 18:31

Well it would seem I have discovered something new with the co2 mags. If your going to store them with a powerlet in... do not leave them on there side. The liquid co2 seems to flow into the valve and cause it to leak. I just had 2 randomly start leaking on me.

Makes me wonder if co2 is better stored with out the powerlet. The one sealed up again after a few shots the other one refuses to seal.

Edit: ok I found a solution to make the mags stop leaking. Seen as the seal on the co2 mags doesn't seem to be rubber so its not reacting to silicone like normal. I found that by stretching the cone spring out a bit it puts more pressure on the valve and seals it up.

On a side note can someone pull a GG valve to compare?

September 24th, 2010, 18:31	#442
Dart Trader rating Join Date: Apr 2009 Location: Grande Prairie Alberta	Well it would seem I have discovered something new with the co2 mags. If your going to store them with a powerlet in... do not leave them on there side. The liquid co2 seems to flow into the valve and cause it to leak. I just had 2 randomly start leaking on me. Makes me wonder if co2 is better stored with out the powerlet. The one sealed up again after a few shots the other one refuses to seal. Edit: ok I found a solution to make the mags stop leaking. Seen as the seal on the co2 mags doesn't seem to be rubber so its not reacting to silicone like normal. I found that by stretching the cone spring out a bit it puts more pressure on the valve and seals it up. On a side note can someone pull a GG valve to compare? Last edited by Dart; September 24th, 2010 at 19:23..