Airsoft Canada - View Single Post

5.56 · September 27th, 2010, 11:06

Hello, all. I bought a short-barreled aeg from a friend, which has a Patriot Kit on the foreend/handguard.
I decided to replace the foreend/handguard with this type of RIS handguard:

http://www.khmountain.com/airsoft/pr...roducts_id=615

However, upon installing it, I noticed that my whole outer barrel assembly is popping out of the front end of my RIS handguard and, that this handguard does not have anything to mount it on to stay in place.
I realized maybe I need a Delta Ring Nut, or something with a diameter small enough to lock the whole outer barrel assembly in place onto the receiver; which will hopefully also allow me mount this RIS on top of.

So far, I haven't been able to locate a Delta Ring Nut, or any Delta Ring kits that could fix this. Any advice?

September 27th, 2010, 11:06	#1
5.56 Trader rating Join Date: May 2007 Location: Burnaby	Delta Ring Nut? Hello, all. I bought a short-barreled aeg from a friend, which has a Patriot Kit on the foreend/handguard. I decided to replace the foreend/handguard with this type of RIS handguard: http://www.khmountain.com/airsoft/pr...roducts_id=615 However, upon installing it, I noticed that my whole outer barrel assembly is popping out of the front end of my RIS handguard and, that this handguard does not have anything to mount it on to stay in place. I realized maybe I need a Delta Ring Nut, or something with a diameter small enough to lock the whole outer barrel assembly in place onto the receiver; which will hopefully also allow me mount this RIS on top of. So far, I haven't been able to locate a Delta Ring Nut, or any Delta Ring kits that could fix this. Any advice? Last edited by 5.56; September 27th, 2010 at 11:07.. Reason: Spelling