Airsoft Canada - View Single Post

juicy · November 18th, 2010, 23:07

Did you remove enough material from your slide rails?

Edit: yup, just tested with half full mag, stock valves, both SA custom "200%" (more like 120-140% IMO) and stock recoil spring, stock springs, fitted and partially polished slide rails, with PGC Glock 17 slide running with barrel. Guarder loading nozzle/floating valve assembly, tested with: stock piston head, PDI piston head, something that resembles a Dyna but isn't a Nine Ball. Cycled fully to slide lock with all configurations.

I know when I was first installing my PGC slide, I initially had it fitted nice and tight - no rattles. Had cycling issues, so took a little more material off and finished it with high-grit sandpaper again. Slight rattle, but it cycled great.

November 18th, 2010, 23:07	#9
juicy Trader rating Join Date: Nov 2009 Location: Richmond, BC	Did you remove enough material from your slide rails? Edit: yup, just tested with half full mag, stock valves, both SA custom "200%" (more like 120-140% IMO) and stock recoil spring, stock springs, fitted and partially polished slide rails, with PGC Glock 17 slide running with barrel. Guarder loading nozzle/floating valve assembly, tested with: stock piston head, PDI piston head, something that resembles a Dyna but isn't a Nine Ball. Cycled fully to slide lock with all configurations. I know when I was first installing my PGC slide, I initially had it fitted nice and tight - no rattles. Had cycling issues, so took a little more material off and finished it with high-grit sandpaper again. Slight rattle, but it cycled great. Last edited by juicy; November 18th, 2010 at 23:17..