Airsoft Canada - View Single Post

Greenwolf · January 24th, 2011, 18:55

Well I've got a small problem.

I was test firing a new CA G36k I recently acquired, and was holding the bolt open with the charging handle to adjust the hop up... I guess I was pulling a bit too hard because suddenly the end piece that rotates 90 degrees so you can operate the charging handle easier snapped off.

Unfortunately I dropped the damn piece in surprise and now I can't find the bloody thing. I checked Airsoftparts.ca to see if they had a replacement, and unfortunately they do not. Does anyone know how or even if I can replace this piece?

*UPDATE* Found the missing piece, may be able to fix with a bit of super glue and epoxy. I would still prefer to outright replace the piece so I'm not dealing with a weakened repaired component.

January 24th, 2011, 18:55	#1
Greenwolf Talraga Trader rating Join Date: May 2006 Location: Kingston	G36 Charging handle? Well I've got a small problem. I was test firing a new CA G36k I recently acquired, and was holding the bolt open with the charging handle to adjust the hop up... I guess I was pulling a bit too hard because suddenly the end piece that rotates 90 degrees so you can operate the charging handle easier snapped off. Unfortunately I dropped the damn piece in surprise and now I can't find the bloody thing. I checked Airsoftparts.ca to see if they had a replacement, and unfortunately they do not. Does anyone know how or even if I can replace this piece? UPDATE Found the missing piece, may be able to fix with a bit of super glue and epoxy. I would still prefer to outright replace the piece so I'm not dealing with a weakened repaired component. __________________ Last edited by Greenwolf; January 24th, 2011 at 19:13..