Quote:
Originally Posted by W0lf
iv thought of this aswell, im still gauging info and staring at them assembled and dissassembled. i wont jump the gun and just start gnawing away at stuff.
|
no no, for sure... i wasn't suggesting jumping to grinding, i'm just providing possibilities a la brainstorm
and i agree with coachster and ross.... i simply can't conceive how it could possibly fit and work before you did the sealing, and then not work after the sealing....
I personally did 7 propane mag seals this week, and none of them ran into that problem with my scar...
edit: looking at that third picture, i remembered something from when I was sealing my mags... if you have the lower receiver out when you put everything in, the mag WILL go a bit further than it would otherwise, because there isn't a brass tube to stop it... take another look at the difference between the two, but pull down on the mag after you insert it, to make sure the mag catch is what's keeping it in place...
I think there might be an irregularity in the feed lip gas port rubber... it looks slightly higher compared to the black mag... but that shouldn't make a difference, as that rubber should compress on mag insertion...