Airsoft Canada - View Single Post

lurkingknight · November 9th, 2011, 10:13

imo it wasn't worth it to try and dremel a real grip to try and fit, there's a lot of places an airsoft gun is different than RS when you start taking off externals.

I tried a RS hogue grip for my kwa and spent 2-3 hours carefully dremelling out the areas that needed to be cut, and it still didn't fit, in the end, I wasted 40$ on a ruined hogue grip cause parts of it ended up being too thin and it still didn't fit. Too bad, it was super comfortable.

I've been told though that TM/kwj might be slightly less than 1:1 to RS in size, while the KWA seems to be slightly more than 1:1 in width of the frame handle. You might have better luck than me since you don't have a kwa. But be prepared to sacrifice your RS parts. Or I just completely failed at dremeling.

November 9th, 2011, 10:13	#7
lurkingknight "bb bukakke" KING! Trader rating Join Date: Jul 2011 Location: Ottawa	imo it wasn't worth it to try and dremel a real grip to try and fit, there's a lot of places an airsoft gun is different than RS when you start taking off externals. I tried a RS hogue grip for my kwa and spent 2-3 hours carefully dremelling out the areas that needed to be cut, and it still didn't fit, in the end, I wasted 40$ on a ruined hogue grip cause parts of it ended up being too thin and it still didn't fit. Too bad, it was super comfortable. I've been told though that TM/kwj might be slightly less than 1:1 to RS in size, while the KWA seems to be slightly more than 1:1 in width of the frame handle. You might have better luck than me since you don't have a kwa. But be prepared to sacrifice your RS parts. Or I just completely failed at dremeling.