Quote:
Originally Posted by lurkingknight
imo it wasn't worth it to try and dremel a real grip to try and fit, there's a lot of places an airsoft gun is different than RS when you start taking off externals.
I tried a RS hogue grip for my kwa and spent 2-3 hours carefully dremelling out the areas that needed to be cut, and it still didn't fit, in the end, I wasted 40$ on a ruined hogue grip cause parts of it ended up being too thin and it still didn't fit. Too bad, it was super comfortable.
I've been told though that TM/kwj might be slightly less than 1:1 to RS in size, while the KWA seems to be slightly more than 1:1 in width of the frame handle. You might have better luck than me since you don't have a kwa. But be prepared to sacrifice your RS parts. Or I just completely failed at dremeling.
|
I agree with the above. I was able to get my hogue wrap around grip 90% of the way and gave up after about an hour of swearing. Its just little high spots that are rasied up that dont make the back flush. But it is possable to get it super close. It's just a matter of fine tuning.