Airsoft Canada - View Single Post

Union · December 15th, 2011, 17:23

THIS is the kind of question I was hoping to have. That sounds good. And I was think about removing all the internals and sand/polish only the exterior of the whole frame, without touching the non-visible mechanical parts (ie : The tip of the magazine that connects to the chamber etc...) so I dont see why I would have any mechanical problems...

Thanks again!

Edit : What do you mean by my gun probably not machined from still? The gun is full-metal I must missunderstand your sayings...It's a KWC Tangfoglio Witness 1911 full metal...Basicly the closest replica I could find of the 1911...Actually pretty amazing realistic wise...

December 15th, 2011, 17:23	#3
Union Trader rating Join Date: May 2007 Location: Canada - Quebec - Montreal	THIS is the kind of question I was hoping to have. That sounds good. And I was think about removing all the internals and sand/polish only the exterior of the whole frame, without touching the non-visible mechanical parts (ie : The tip of the magazine that connects to the chamber etc...) so I dont see why I would have any mechanical problems... Thanks again! Edit : What do you mean by my gun probably not machined from still? The gun is full-metal I must missunderstand your sayings...It's a KWC Tangfoglio Witness 1911 full metal...Basicly the closest replica I could find of the 1911...Actually pretty amazing realistic wise... __________________ No advertising of services if not paid up on retailer subscription fees. Last edited by Union; December 15th, 2011 at 17:30..