Airsoft Canada - View Single Post

Ballcancer · January 17th, 2012, 22:47

Or a cheaper alternative; when I had my OB, I just put a 3mm high blob of JB Weld on the bottom of the bolt catch, where the magazine bolt lock tab is supposed to make contact, let it sit for 24 hrs until it was cured properly and voila! Bolt catch worked like a charm.

Also if you are going to go this route, make sure that the surface is clean of anything... make sure that the surface is rough as well so the JB weld has something to bite into.

January 17th, 2012, 22:47	#3
Ballcancer Trader rating Join Date: Oct 2009 Location: Gravenhurst, ON	Or a cheaper alternative; when I had my OB, I just put a 3mm high blob of JB Weld on the bottom of the bolt catch, where the magazine bolt lock tab is supposed to make contact, let it sit for 24 hrs until it was cured properly and voila! Bolt catch worked like a charm. Also if you are going to go this route, make sure that the surface is clean of anything... make sure that the surface is rough as well so the JB weld has something to bite into. __________________ Last edited by Ballcancer; January 17th, 2012 at 23:00..