[O.S.O.K]

I've put all the stock open bolt trigger parts back in and it seems they work fine still not firing correctly though but that seems to be more of a gas delivery issue at this point, be it either due to mags not seating fully up into the mag well or because the nozzle has seen its final days. Need a new nozzle for sure regardless as the rear O-ring is completely gone. Oh and one other thing that might be contributing to the issue, while using the RA tech steel bolt lower on the steel or even the stock upper the bolt will not go completely forward, it stays roughly 3/4 of a centimeter back.

Upon inspection the RA tech lower is noticeably different from the stock but I've yet to confirm the point of friction or meeting it two parts that is causing this.

I'm about at the end of my rope trying to get this thing working myself so I'm just going to take it in and let them deal with it, $60 is worth less than all the time I've spent on it thus far.

And if that and the fact that my other rifle isn't firing (cheap stock Chinese parts to be replaced soon) went to fire my KWA 1911 ptp earlier this evening and the god damn cylinder snapped in half.... It fired less than 200 rounds, properly maintained never dropped and it was a dry fire... Must have just been a faulty casting.

Thanks for the info.