Airsoft Canada - View Single Post

-Shade · June 18th, 2013, 21:29

Wow - these are all great ideas. I may try the wider screw size - but I'm sure I'll figure out something. The other side is still holding strong. I can't see how a piece like this would be hard to make though. I may have access to the appropriate equipment so it could be doable. I don't even think it needs to be curved to fit in the RIS, that may just be for style or for the original M14, not the bigger EBR RIS.

On a side note, does anyone know where I could find the part number for this thing? Or an original TM part list for an M14 or EBR?

June 18th, 2013, 21:29	#6
-Shade Trader rating Join Date: Feb 2013 Location: Oakville - ON	Wow - these are all great ideas. I may try the wider screw size - but I'm sure I'll figure out something. The other side is still holding strong. I can't see how a piece like this would be hard to make though. I may have access to the appropriate equipment so it could be doable. I don't even think it needs to be curved to fit in the RIS, that may just be for style or for the original M14, not the bigger EBR RIS. On a side note, does anyone know where I could find the part number for this thing? Or an original TM part list for an M14 or EBR? Last edited by -Shade; June 20th, 2013 at 10:11..