Quote:
Originally Posted by HackD
Keep in mind, if you follow through with this.. even though you've got a metal barrel threading/upper receiver assembly.. an additional o-ring crushed down will make the whole assembly much more rigid/less prone to receiver/RIS rotation... in my experience anyway. I ended up going RASFix to totally eliminate that issue, in the end, with this sort of integral RIS/receiver combos.
|
Alright this is kinda a little update on whats going on with the rail
I ground down the tabs on the barrel, i put the slip-ring on, it was somewhat not screwed on completely otherwise the rail would be too low and not wrap around the threading area properly so i assume the slip-ring not being tightly screwed on is normal?
Screwed the two rail halves together, positioned it onto the slip-ring then screwed the allen key set screws into the slip ring, to my surprise after screwing it for a bit the rail is sitting rigid on the receiver though i don't know if its screwed in enough, it seems sturdy.
the question is if its sitting sturdy is it good or should i screw the allen key screws in until they won't budge
EDIT: Okay so I decided to really tighten the allen keys screws and it seems fine, nice and sturdy so hopefully it won't be going anywhere