Just get a battery upgrade bro. Swiss cheesing and removing bearings are not necessary. Pre-engagement really only happens when you get a jam in your barrel or you're getting feeding problems. I have 30 RPS setups doing anywhere from 300FPS to 450FPS, one of my guns ran a M90 spring, lonex piston without swiss cheesing and aluminum piston head with bearings at 30 RPS and no pre-engagement happened.
Quote:
Originally Posted by Pointy
As far as I can tell, no pre-engagement with current setup (7.4VDC LiPo 25-50C 1200mAh).
I assume that it would be pretty noticeable if I was getting pre-engagement.
Doh, the 11.1VDC LiPo I have is 1200mAh 25-50C.
I am thinking I'll get the Lonex A2 motor now and run on a 7.4VDC LiPo (as I am concerned about my stock motor).
Then once I feel like opening my gearbox again I can swiss-cheese the piston, remove the piston head bearings and run my 11.1 LiPo.
Believe the Lonex A2 should be good for both scenarios?
|