Airsoft Canada - View Single Post - slide lock non lock puzzler HK45T and Umarex HK45CT

Ratters · June 6th, 2020, 21:11

Attachment 60584
Attachment 60587
Attachment 60585

Attachment 60586You know those bins of springs and screws and all that crap we accumulate over the years? That stuff we sometime say "maybe I should turf it because i'll never use it"? Well my advice is don't and i'll explain why so you can have a happy shooting TM HK45 without any lock back issues ever again.

M16 barrel spring.

Drop it in the TM HK45/T outer barrel, drop in that silver locking piece, replace the barrel and hop, put the screw in.

Reassemble, test the action, put in the mag and instant smiles.

Adequate magazine follower spring tension is also needed as this pistol and others I've tested, four in total now, all have a partial engagement problem on the slide stop with the supressor off.

My pistol now locks back, dry firing with a hi-flow nine-ball valve, standard Marui magazine valve and with the shorty supressor on or off.

This has been a learning experience for me through trial and error. I hope that some of you, willing to try what I've done, can try the same modifications and benefit from them.

None of these mods permanently change your pistol, they are all 100% reversable in a matter of seconds with no detrimental affect to the pistol while they are installed.

Happy shooting

June 6th, 2020, 21:11	#8
Ratters Trader rating Join Date: Jul 2003 Location: Vancouver	The fix is in folks, you can thank me later for the doubters Attachment 60584 Attachment 60587 Attachment 60585 Attachment 60586You know those bins of springs and screws and all that crap we accumulate over the years? That stuff we sometime say "maybe I should turf it because i'll never use it"? Well my advice is don't and i'll explain why so you can have a happy shooting TM HK45 without any lock back issues ever again. M16 barrel spring. Drop it in the TM HK45/T outer barrel, drop in that silver locking piece, replace the barrel and hop, put the screw in. Reassemble, test the action, put in the mag and instant smiles. Adequate magazine follower spring tension is also needed as this pistol and others I've tested, four in total now, all have a partial engagement problem on the slide stop with the supressor off. My pistol now locks back, dry firing with a hi-flow nine-ball valve, standard Marui magazine valve and with the shorty supressor on or off. This has been a learning experience for me through trial and error. I hope that some of you, willing to try what I've done, can try the same modifications and benefit from them. None of these mods permanently change your pistol, they are all 100% reversable in a matter of seconds with no detrimental affect to the pistol while they are installed. Happy shooting __________________ Can´t sleep. Clowns will eat me! Last edited by Ratters; May 25th, 2021 at 17:48..