Quote:
Originally Posted by beta678
*Facepalm*
Think I might know what the problem is but I'd like some input as I'm not 100% sure. Is the air seal nozzle supposed to be springy? As in you should be able to push the nozzle inward and it should spring back out?
I think I may have installed the nozzle under the tappet plate instead of on it as it does not have any movement at all. I'll open the gearbox to see if that's the case and fix it tomorrow.
If that's not the issue then I'm still stumped.
|
Its supposed to be springy yes, and this would be whats causing the problem cause the nozzle is not moving back to load the bb properly