Airsoft Canada - View Single Post - Tokyo Marui Hi-Capa 5.1 and Prog4 hammer set upgrade problem

hawai · August 26th, 2014, 19:41

Hi,

I am new here and also to the world of Airsoft IPSC pistols. I just came across of this nice forum with lot of usefull info, thanks for that !

I have a question about a hammer set upgrade / modification for my Tokyo Marui Hi-Capa 5.1. I have the following ''Prog4'' hammer set :

With this hammer set from Prog4, i have replaced the orginal Sear, Knocker, Hammer Spring Plunger and of course the Hammer and Strut from my Tokyo Marui Hi-Capa 5.1.

If i put the lower receiver and grip together again and try to fully cock the hammer and pull the trigger, the hammer stops half way and the Knocker won't get slammed by the hammer.

If i ONLY put the orginal TM hammer en strut back and test the same, the hammer will fully decock when pulling the trigger and everything seems to be working fine. I have looked to see any differences between the TM and Prog4 hammers, but i just can't find any clue for this problem.

Can somebody help me ? Thanks a lot !

August 26th, 2014, 19:41	#1
hawai Trader rating Join Date: Aug 2014 Location: Netherlands	Tokyo Marui Hi-Capa 5.1 and Prog4 hammer set upgrade problem Hi, I am new here and also to the world of Airsoft IPSC pistols. I just came across of this nice forum with lot of usefull info, thanks for that ! I have a question about a hammer set upgrade / modification for my Tokyo Marui Hi-Capa 5.1. I have the following ''Prog4'' hammer set : With this hammer set from Prog4, i have replaced the orginal Sear, Knocker, Hammer Spring Plunger and of course the Hammer and Strut from my Tokyo Marui Hi-Capa 5.1. If i put the lower receiver and grip together again and try to fully cock the hammer and pull the trigger, the hammer stops half way and the Knocker won't get slammed by the hammer. If i ONLY put the orginal TM hammer en strut back and test the same, the hammer will fully decock when pulling the trigger and everything seems to be working fine. I have looked to see any differences between the TM and Prog4 hammers, but i just can't find any clue for this problem. Can somebody help me ? Thanks a lot !