Airsoft Canada - View Single Post - King Arms Version 3: Do I dare use it stock?

KingOfTime · September 1st, 2015, 21:23

Hi, I'm not a really a 'n00b' with gearboxes, I'm just not fully educated on the best fitment/setup. I already know the basics, etc. etc. I just have a question about a piston head/cylinder head configuration used in a pre-assembled King Arms (which I now think was a mistake) version 3 gearbox. They happened to use a metal piston head (from what I know can be hard on a gearbox) with a silenced cylinder head, which of course is SUPPOSED to be matched with a silenced or rubber-head piston head to fit in the whole of the cyl. head.

My question is: How much damage would this pre-assembled setup do to the gearbox as a whole? Is it even safe to fire a few shots to try it before I do change the cylinder setup??

September 1st, 2015, 21:23	#1
KingOfTime Trader rating Join Date: Sep 2015	King Arms Version 3: Do I dare use it stock? Hi, I'm not a really a 'n00b' with gearboxes, I'm just not fully educated on the best fitment/setup. I already know the basics, etc. etc. I just have a question about a piston head/cylinder head configuration used in a pre-assembled King Arms (which I now think was a mistake) version 3 gearbox. They happened to use a metal piston head (from what I know can be hard on a gearbox) with a silenced cylinder head, which of course is SUPPOSED to be matched with a silenced or rubber-head piston head to fit in the whole of the cyl. head. My question is: How much damage would this pre-assembled setup do to the gearbox as a whole? Is it even safe to fire a few shots to try it before I do change the cylinder setup??