Airsoft Canada - View Single Post - Dytac Rail systems any good? (M-lok recommendations?)

EOD Steve · February 5th, 2016, 10:27

If you are putting this on a VFC, you will have to shave down the sides of the upper receiver immediately below the barrel nut, on each side of the takedown pin for clearance for the torque plate.
Some RS billet receivers have this issue so it's not strictly an airsoft thing.

February 5th, 2016, 10:27	#10
EOD Steve Trader rating Join Date: Jun 2012	If you are putting this on a VFC, you will have to shave down the sides of the upper receiver immediately below the barrel nut, on each side of the takedown pin for clearance for the torque plate. Some RS billet receivers have this issue so it's not strictly an airsoft thing. __________________ The Steve has spoken. Last edited by EOD Steve; February 5th, 2016 at 10:29..