Quote:
Originally Posted by Syndakit
What part did you find too difficult?
|
Only one of the patches was anywhere close to being the right fit for the EDGi barrel...and after leaving it to cure for 24 hours to patch simply popped right off.
Using black permatex rtv. Tried twice. Once using just a small amount on all four sides and rubbing some on the outside, and then the second time using a fairly large amount..same result. Using 400 grit sandpaper just like the video shows...just falls off within the first few passes.
Plus the experience in general of not being sure of what the fuck im doing, how far to go for cutting, sanding ect.
I work 70 hours a week, this was a waste of my limited time and money.
Sent a message to Ziming/Pesto. Hopefully I can get a proper patch put in before the milsim next week.