Airsoft Canada - View Single Post

Rigio · January 27th, 2019, 23:19

the issue is that the two piece hop up doesn't work in the new receiver as it does not have the bracket that holds the lower part of the hop up. I'm wondering if anyone has modified the two piece hop up to a one piece by gluing/epoxy the two together. If so were there any issues with the lower receiver not aligning properly with the mag.

I've tried googling solutions in hopes of finding someone that has successfully modded the hop up in this way but haven't had any luck. Was hoping someone here would have some insight.

January 27th, 2019, 23:19	#6
Rigio Trader rating Join Date: Jan 2019	the issue is that the two piece hop up doesn't work in the new receiver as it does not have the bracket that holds the lower part of the hop up. I'm wondering if anyone has modified the two piece hop up to a one piece by gluing/epoxy the two together. If so were there any issues with the lower receiver not aligning properly with the mag. I've tried googling solutions in hopes of finding someone that has successfully modded the hop up in this way but haven't had any luck. Was hoping someone here would have some insight. Last edited by Rigio; January 27th, 2019 at 23:22..