|
if it's a TM mk23 heres the info
take slide off:
- pull slide back about an inch or so, you'll notice the lever (acts as a safety) has a tit on it, there is a notch in teh slide .. match the two up.
- push from the right hand side of the gun the leaver ... on one side you have the lever, the other side of the gun you see a round hole of hte pin that hold the leaver in .. push this pin and the whole leaver comes out
- push slide towards front of gun and the slide comes off.
- to get slide on .. you'll hae to match up the nothces of the slide with teh notches of the base of the gun ... pretty tricky the first few times you do this .. but you'll get it
now as to fill yoru mags ..
- from empty only fill for 3 seconds max .. shoudl be more then enough
- from half full or unknown ammount in mag ... just fill till the gas begins to squirt liquid out
- after you fill the mags make sure you let it warm up to room temp .. about 2 - 5 minutes before you start shooting the gun or the gas will get used up pretty quick.
hopefully the presure releif valve doens't go on you .. but if it does i've got a word document that shows how to fix it.
|