Airsoft Canada - View Single Post - Putting KSC Glock firing/hammer mechanism back together tricks?

v82slo · December 21st, 2005, 09:38

I had to replace part #83 in the firing mechanism (http://www.wargameclub.com/gun-folde...17-install.htm) off my KSC G19 as it broke and caused misfiring. So far I've been able to take apart the mechanism and not lose any springs. The problem I'm running into is putting everything back together.

Is there any tricks for putting the firing mechanism back together? The spring on the firing pin keeps causing the firing pin (part #78 ) to move out of alignment and I can't get the rest of the pieces back together without the pin either coming off or misaligning.

Any help would be appreciated. I do see how everything is suppose to fit together but just can't the pieces to play along. Am I suppose to remove part #62 to make the install easier?

December 21st, 2005, 09:38	#1
v82slo Trader rating Join Date: Aug 2003	Putting KSC Glock firing/hammer mechanism back together tricks? I had to replace part #83 in the firing mechanism (http://www.wargameclub.com/gun-folde...17-install.htm) off my KSC G19 as it broke and caused misfiring. So far I've been able to take apart the mechanism and not lose any springs. The problem I'm running into is putting everything back together. Is there any tricks for putting the firing mechanism back together? The spring on the firing pin keeps causing the firing pin (part #78 ) to move out of alignment and I can't get the rest of the pieces back together without the pin either coming off or misaligning. Any help would be appreciated. I do see how everything is suppose to fit together but just can't the pieces to play along. Am I suppose to remove part #62 to make the install easier? __________________