January 14th, 2006, 23:24
|
#2
|
|
|
Quote:
|
Originally Posted by BIGMEDCIN
Question:
Has anyone removed material from an Aluminum piston.
Can you make a Aluminum piston lighter without making it unreliable?
were could this be done, cross drill holes?, flute the lenght of it?
enlarge spring area?
my piston has half teeth, I would like to make it less stressfull on my ver-2 mech box, and not take to big of a hit on rate of fire, so if I can lighten it with out too much problem why not ?.
thanks
|
The Top Power aluminum pistons were skeletonized. Every person I know personally who had one ended up removing it, or shredding it.
__________________
Quote:
Originally Posted by TokyoSeven
That was a very bad move on your behalf. Sort of like cutting off your foot for money, but not getting the money first and then letting the person with the money run away.
|
Quote:
Originally Posted by MadMorbius
Liberals rely on emotion. Conservatives rely on evidence, and the Socialists rely on everyone else.
|
|
|
|