[deep in the bush]

hey ya all...

I have a question about running the wires out to the buttstock on a tm g36c...I am getting the wires to run out of the back...where do you suggest? I would rather not drill a new hole but if I have to...where do you recomend to drill to cause the least amount of structural integrity?

just a few questions as "ole bessy" is off to get the wiring done.

I also plan to run the fuse outside of the gun in the buttstock as it will be easier to change ...even though i rarely had to...as far as the fuse and the elements I plan to use a fuse holder.

I was thinking to if i have to drill i was going to run it out of the top of the top rail/handle and run it along the side...but if any better ideas are out there please let me know.

I run with a 8.4v 3000mah...runs all day and then some.

ditb

p.s. please excuse the tape...it's gone now...btw grey...it came off just fine...but thanks for the warning.