Quote:
Originally Posted by Styrak
I hope those aren't crap 0.12's? That would be bad to fuck up your gun, would it not?
|
Just have to put them in a plastic container and shake them for about 1 hour.... most seam defects will be gone and it should not jam as much.
And I use some neon green ones... you know the ones at Walmart... 20$ for 10000....hell I think I will have forever to go through the 10000.... Mostly because I don't have any AEG left...BA and handgun only.
I think it would be quite easy to do with an aluminium follower... just have to run a signal in the spring, which will go in the follower, then have a small metal part added to the side of the mag...all linked to 2 friction connection on the mag...
Only problem I see is with metal mags...
And beside, to be able to cut-off the power when you are out of ammo, then have to recock the gun to start firing.... You only have 3 choices.
1- have a relay circuit with a NO relay, loop it to a Boolean logic switch and maybe an inverter (depends on the way used to detect the "no ammo"). It will cause some errors once in a while and might not be accurate enought to actually work. Then have a parallel "reboot" circuit to repower the relay when recocked. You will always consume a lot of energy just to keep it running. And you will have to find a big cube shaped space to fit the relay (considering the currents involved, I think 1.5"x1.5"x1.5" would be a good aproximate).
2- Use a huge logic circuit. It will consume energy even when in "shut down" and will be kinda bulky. (unless you are able to make it in surface mounted components)
3-Use a programable micro-controler and a relay, using the same as up there, but it would allow for an auto reboot after a given time, or "dry fire" mode...if programmed well. It surely will cause a lag in the response and might not be efficient enought to be uses here. Positive is that it would be possible to calibrate the margin of error a lot more and it could be the most efficient solution.
HELL! It would be easier to make my kitchen prepare a breakfast linked on my alarm clock than to make this thing work!
Just stick some colorfull BBs in there and keep an eye for them. Plus I don't know for yu but I know right away when I fire the first "blank". Sounds a lot different. Just ease on the full-auto-spray-and-pray and you won't have to worry.