|
Make sure your bolt handle and boss (the cap that holds the bolt handle in place) are snugged down well, that could cause problems.
Also, there could be a very good chance a BB popped out of your mag when you were cycling the gun and fell inot the hole at the rear of the hop up unit, and is sitting between your cylinder head and the hop up unit, preventing the cylinder form going full forward. Has happened to me about a half dozen times in the 4 years I've owned my CA M24 (mostly caused by mags with busted feedlips as well as cocking the gun at higher than level angles............ pull cylinder back, bad feed lip causes a BB to pop out, it rolls back and into the cylinder chamber).
|