Airsoft Canada - View Single Post

MadMax · August 10th, 2007, 23:18

http://www.airsoft-innovations.com/product5.html

http://www.airsoft-innovations.com/product6.html

Not exactly earth shaking products, but I'm finally getting back into the swing of things and launching new goodies.

The first product is a bushing press to help the AEG mechanic press bushings and ball bearings into their mechboxes squarely. It might even be the only press available to safely press ball bearings as this press only loads the outer race. It's design prevents the installer from hammering the inside race when forcing the outer race into the gearbox. The design of this press assures perpendicular alignment in gearbox sides.

The second doohickey is a simple little motorplate which press fits into the tail end of most AEG motors (TM, ICS, CA, GG). Once installed, it doesn't fall off like the flat motorplates typical in airsoft. You can also pack grease into the end bell before installing the motor plate to keep the bushing lubricated.

August 10th, 2007, 23:18	#1
MadMax Delierious Designer of Dastardly Detonations Trader rating Join Date: Dec 2001 Location: in the dark recesses of some metal chip filled machine shop	New thingies at Airsoft Innovations! http://www.airsoft-innovations.com/product5.html http://www.airsoft-innovations.com/product6.html Not exactly earth shaking products, but I'm finally getting back into the swing of things and launching new goodies. The first product is a bushing press to help the AEG mechanic press bushings and ball bearings into their mechboxes squarely. It might even be the only press available to safely press ball bearings as this press only loads the outer race. It's design prevents the installer from hammering the inside race when forcing the outer race into the gearbox. The design of this press assures perpendicular alignment in gearbox sides. The second doohickey is a simple little motorplate which press fits into the tail end of most AEG motors (TM, ICS, CA, GG). Once installed, it doesn't fall off like the flat motorplates typical in airsoft. You can also pack grease into the end bell before installing the motor plate to keep the bushing lubricated. __________________ Want nearly free GBB gas? Last edited by MadMax; August 10th, 2007 at 23:59..