Airsoft Canada - View Single Post

mcguyver · November 8th, 2007, 00:24

A gun doc used to working on Marui-based guns won't be able to help you much with a PTW.

I also can't see how your stock tube got cross-threaded in the receiver, unless you cracked the lower receiver. Pray this didn't happen, as you will have a bit of a hrad time getting your hands on one. They are controlled items in Canada and you'll have to go to a retailer to get them to order one in for you.

If the threads are damaged, but the receiver is intact and not cracked, you should be able to repair it. I'm not so sure about heating it, but the threads are flat, so maybe. An armourer's wrench with telestock option or a telestock wrench will be needed to tighten up the barrel nut so this won't happen again.

On that note, was this a SCK or a pre-assembled gun?

November 8th, 2007, 00:24	#2
mcguyver Trader rating Join Date: Aug 2005 Location: Northern Alberta	A gun doc used to working on Marui-based guns won't be able to help you much with a PTW. I also can't see how your stock tube got cross-threaded in the receiver, unless you cracked the lower receiver. Pray this didn't happen, as you will have a bit of a hrad time getting your hands on one. They are controlled items in Canada and you'll have to go to a retailer to get them to order one in for you. If the threads are damaged, but the receiver is intact and not cracked, you should be able to repair it. I'm not so sure about heating it, but the threads are flat, so maybe. An armourer's wrench with telestock option or a telestock wrench will be needed to tighten up the barrel nut so this won't happen again. On that note, was this a SCK or a pre-assembled gun? __________________ Age verifier Northern Alberta Democracy is two wolves and a sheep discussing what's for dinner. Freedom is the wolves limping away while the sheep reloads. Never confuse freedom with democracy.