Airsoft Canada - View Single Post

Long_Bong · March 28th, 2008, 20:41

Hi,

Newbie toying with his AK.

I changed the Hop Up unit of a Kraken Ak for a alum pro win one.
Mechbox was fully overhauled by Stalker.
Assembled the whole thing back on. With a Promotheus SP100. 215 fps with 0.25 bb and no hop up. A bit low I would say. So, remember Stalker mentionning that to verify your airseal, run on full, stop and do so until the airnozzle is fully extended. Then, put a flashlight were the feeding hole is and look in the other end of the barrel. No light = good seal. Light = bad seal.

From this picture, you can see that it would appear that my airnozzle is not ling enuff to do a complete seal. I m a right, is this the problem? Should I change the airnozzle (for a longer one)? It a AK 47 airnozzle got on ehobby.

Thanks,

Bong

March 28th, 2008, 20:41	#1
Long_Bong Trader rating Join Date: Dec 2007 Location: Canada	Kraken AK 47 airnozzle issue Hi, Newbie toying with his AK. I changed the Hop Up unit of a Kraken Ak for a alum pro win one. Mechbox was fully overhauled by Stalker. Assembled the whole thing back on. With a Promotheus SP100. 215 fps with 0.25 bb and no hop up. A bit low I would say. So, remember Stalker mentionning that to verify your airseal, run on full, stop and do so until the airnozzle is fully extended. Then, put a flashlight were the feeding hole is and look in the other end of the barrel. No light = good seal. Light = bad seal. From this picture, you can see that it would appear that my airnozzle is not ling enuff to do a complete seal. I m a right, is this the problem? Should I change the airnozzle (for a longer one)? It a AK 47 airnozzle got on ehobby. Thanks, Bong __________________