|
I am in the process of upgrading a Well rifle.
It is the G22, basically a L96 with a custom stock and a gaz bolt.
I dropped a PDI Lv.3 Cylinder set, PSS2 120%-210% spring, PDI hop-chamber, Prometheus Hard type hop packing, Deep Fire SS 6.04 Tightbore (I hear that 6.02 was too tight and accuracy was worst from a know guntech).
Also ordered 3 Maruzen magazines, they all fit properly.
There is some filling to do, since the tolerance of the clone parts is lower. In particular the bolt handle, it was molded a tiny bit taper, so the cylinder would not fit loose enought to be usable. The air seal of the cylinder is the closest to perfection I ever was. Plugged the nozzle for a good 15 minutes, with the 120% spring pushing on the piston. It never moved.
So far, there is not a single upgrade that I can't install in the Well rifle.
Yes the stock triggerbox is plastic, but a Maruzen APS-2 Type 96 also comes with a plastic trigger box. I ran a 550 fps setup on the stock box no problem. I can't find lightweight triggers instock anywhere, so I am going to run the stock box till it dies.
BTW, the 210% spring need my both hands to crank... with the rifle pointed down, resting on my shoulder. It is one hell of a hard spring. I when through a plastic cola bottle, with the cap closed. Pierced both sides. To give an idea, the 550fps setup was not making it through a single side.
|